Jack points?

[Nate]

This forum is great, I am very new to the auto world and learning as i go but this is a terrific source of information. My next dilemma is removing a rear fender to be fixed. After looking at the manual for the roadster I am still not sure where the best jack points are located? I spoke to an engineer at Panoz regarding this; however, I am very visual and I don't want to make an expensive mistake. Does anyone have any advice or pictures that may help?

[IkeCan]

Nate, I am also interested in seeing some pictures pointing out the jack points on the Roadster. I have heard that you can damage a channel that runs the length of the car if you don't pay attention to using the jack points on the frame. If anyone could post pictures that would be great.

[Nate]

The engineer at Panoz mentioned jacking up the car in the following locations:
Front - lower control arm, Rear - rear subframe (2x1 steel tube near the exhaust). This is different than what is in the manual and I don't want to chance it. Has anyone else used these jack points?

[sshrum]

I've used the squared steel frame in the past but as my car is currently in the shop I got no pix for ya. When I get my roadster back I'll post some.