Tweet
My last set of tires had some uneven wear and I asked for alignment specs. I'm not sure if they're posted anywhere else but what the heck.....
*****************
"Panoz Auto Development
1101 Highway 124
Hoschton, GA 30548
Contact: Joey McBride
Phone: 770-867-7496
Fax: * *770-307-1714
* For Release 2:29 PM, 3/18/03
Technical Bulletin
Overview…
ALIGNMENT SPECIFICATION 96 – 99 PANOZ ROADSTER
Detailed Steps/Information… * * *Panoz Roadster Alignment Specification
*
Front …
*
Toe-1/16” *to 3/32” *toe-in * * * *Target = 1/8” *total toe-in
*
Caster-6° to 7° * * * Target= * 6.5°
Camber - -1.5° *to *0.5° * * * * * * * Target= -0.5°
*
Rear…
*
Toe-1/16” *to 3/32” *toe-in * * * * *Target= 1/8” Total toe-in
Camber--1.5° to . 0.5° *Target= -0.5°
*
Ride Height…
Front (measured at the main chassis rail in the center of lower control arm, in front of chassis indent)
8 ¼”
Rear (measure at the main chassis rail in front of the rear wheel)
8 ¾ ”
Tire pressure = 28 psi"
*****************
"Panoz Auto Development
1101 Highway 124
Hoschton, GA 30548
Contact: Joey McBride
Phone: 770-867-7496
Fax: * *770-307-1714
* For Release 2:29 PM, 3/18/03
Technical Bulletin
Overview…
ALIGNMENT SPECIFICATION 96 – 99 PANOZ ROADSTER
Detailed Steps/Information… * * *Panoz Roadster Alignment Specification
*
Front …
*
Toe-1/16” *to 3/32” *toe-in * * * *Target = 1/8” *total toe-in
*
Caster-6° to 7° * * * Target= * 6.5°
Camber - -1.5° *to *0.5° * * * * * * * Target= -0.5°
*
Rear…
*
Toe-1/16” *to 3/32” *toe-in * * * * *Target= 1/8” Total toe-in
Camber--1.5° to . 0.5° *Target= -0.5°
*
Ride Height…
Front (measured at the main chassis rail in the center of lower control arm, in front of chassis indent)
8 ¼”
Rear (measure at the main chassis rail in front of the rear wheel)
8 ¾ ”
Tire pressure = 28 psi"
Comment